figures

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

creating 3-D figures

katilluik

There is a fairly simple method of forming three-dimensional figures in the Ten Men system. The necessary preparation is merely to katilluik the bottom index loops after you have formed the loom and before you weave. Katilluik is an inuit word meaning to bring together, and it is accomplished (from the Ten Men loom position) as follows:

Transfer the upper index loop to the middle finger so you can work on the lower index loop.

Bring the hands together and slide the right index finger up through the left index finger loop and lift it entirely off the left index.

Re-insert the left index finger, from below, into both loops on the right index finger and slowly separate the hands. You should now have two loops on the index fingers with two near transverse strings (i.e. strings that run straight across the figure), one far transverse string, and one pair of non-transverse strings (i.e., strings that run into the figure and cross). This complex doubled loop is now the bottom index loop and is treated as a single loop when weaving.

Transfer the loop stored on the middle finger back to the top of the index finger. Make sure the transverse string is nearest you (i.e., don’t invert the loop during the transfers). See fig. 18.

There is, of course, no reason you should not katilluik the upper index loop as well to give a double katilluik loom. This will enrich the figure even more. A simple way to katilluik both index loops without transferring loops to and from the middle finger is as follows: